Bitumen road emulsions are water-based road construction component products with bitumen as the dispersed phase. Bitumen is a nearly insoluble, adhesive, and waterproofing material derived from crude petroleum that is very viscous or nearly solid at room temperature. It is emulsified in water after being treated with surface active additives and other chemicals to reduce its viscosity. This process by a bitumen emulsion manufacturing company in Maharashtra allows for application in road surfacing at lower temperatures than would otherwise be possible. The water phase of the emulsion is naturally removed during application by absorption on the road surface or evaporation, leaving behind a residual bituminous binder. Depending on the chemical structure of the surface active additives, there are two major types of bitumen emulsion manufactured by bitumen emulsion manufacturing companies in Maharashtra.
Safety and Health:
Avoiding skin contact with bitumen emulsion requires the use of safe working techniques and personal protective equipment such as protective gear, impermeable gloves, and boots. Barrier lotions, particularly water-resistant creams, are useful, and staff should use a skin cleanser and thoroughly wash with soap and water after work. Solvents should not be used to remove the remaining bituminous binders from the skin since they might cause irritation.
Bitumen emulsion manufacturing company in Maharashtra recommends that eyes should be protected from emulsion splashes by using safe working practices and wearing appropriate goggles or visors. If the emulsion is accidentally splashed into the eyes, flush them thoroughly with cold water for at least 5 minutes and seek immediate medical attention.
Scalds should be immersed in cold running water for at least 10 minutes, or until fully chilled. Unless circulation is obstructed and medical counsel is sought, no attempt should be made to remove cold bitumen that has clung to the skin.
Handling:
Emulsions should never be heated above 90°C to avoid boiling and dangerous spillage caused by vigorous frothing. Furthermore, heating above 90°C or for extended periods at lower temperatures can damage emulsions, changing their application properties.
Bitumen emulsion manufacturing companies in Maharashtra strongly avoid the substantial danger of spillage if emulsions come into contact with hot bitumen above 100°C due to the fast expansion of the boiling mixture. When converting a storage tank from emulsion to bitumen or vice versa, consult with the bitumen and emulsion providers. Cationic and anionic emulsions should never be combined since they are chemically incompatible and will coagulate with each other, leaving them useless.
Storage in Drums and Packs:
Bitumen emulsions have a limited shelf life depending on the composition and storage circumstances, thus stock should be rotated to ensure that older drums and packs are used first. In general, barrels and packs in storage should be re-homogenized on a regular basis by rolling / inverting to minimize any progressive separation of the bitumen phase. This should also be done right before use to re-homogenize any separation that has occurred. Bitumen emulsion manufacturing companies in Maharashtra recommend that drums and packs should be protected against cold and hot temperatures, which might cause container pressurization.
Waste Disposal:
Bitumen emulsions and the containers they were stored in may be classified as either non-hazardous waste or hazardous waste, depending on the formulation, and both must be disposed of in accordance with applicable legislation.
About Us:
Bedrock Infra is a well-known bitumen emulsion manufacturing company in Maharashtra, offering bitumen emulsion and other bitumen-based road-building materials. Our high-quality road-building supplies, such as bitumen emulsion, are popular among road builders. As one of the most well-known bitumen emulsion manufacturing companies in Maharashtra, we strive to provide high-quality products to our customers.
Related Posts
